Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Washing and storage
WASHING THE BIKE
SHERCO advises you to wash your 250-300
SE/R as often as possible in order to main-
tain it in good working order and prolong its
life.
1. Cover the end of the exhaust silencer and
the air filter (plastic bag, special cover
or a special cap).
2. To degrease the engine, apply a degrea-
ser, clean with a brush then rinse
the engine with a water hose.
3. Wash the rest of the vehicle with hot
soapy water.
4. Rinse with clear water.
5. Dry with a chamois or a clean, soft cloth.
6. Clean the chain and lubricate it with
a special chain lube.
7. When the cleaning is finished, remove the
air filter and exhaust protection, Start the
engine and let it run atidle for a few
minutes.
Avoid using high pressure equipment which
may cause water to leak into the bearings
and fork seals and cause serious damage.
Use an average strength detergent rather
than a strong detergent.
CAUTION
In order to avoid any water ingress, keep a mini-
mal washing distance of 20cm.
STORING THE BIKE
Before storing the vehicle Long-Term (more
than 2 months), follow these instructions :
1. Wash the whole bike.
2. Empty the fuel tank.
3. Remove the spark plug and inject a
protective spray inside the engine through
the hole in the cylinder. Install the spark
plug. Cycle the engine a few revolutions
to apply a protective film on the cylinder
walls.
4. Remove the battery (
5. Charge the battery (
6. Lubricate all cables with a spray lubricant.
7. Jack the motorcycle up so that the wheels
are off the ground.
8. Cover the exhaust outlet with a plastic
bag to prevent moisture from entering.
9. Spray a protective oil film on all unpainted
metal surfaces of the motor and also on
the electrical wiring.
10. Cover the motorcycle with a cover.
RECOMMISSSIONING AFTER
STORAGE
Reinstall the battery (
Fill the fuel tank.
Perform lubrication and maintenance (
Perform a road test.
p.126)
☛
p.127)
☛
p.127)
☛
p.132)
☛
131
Publicité
Chapitres
Table des Matières
