Setting The Fork Compression; Fork Rebound Adjustment - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R
Adjusting the chassis (continued)

SETTING THE FORK COMPRESSION

KAYABA
1

FORK REBOUND ADJUSTMENT

1
1
102
Screws
when it is compressed. Turning in the screw-
1
clockwise increases the hydraulic force (and
vice versa).
Remove the caps
the fork.
2
Turn screw
back the number of clicks required.
Setting compression
WP suspension
XPLOR Ø48mm
(racing)
Setting compression
KAYABA (factory)
Replace the cap
The adjusting screws
of the fork when it rebounds. Turning the screws
clockwise increases the hydraulic force (and vice
versa).
The adjustment screws
of the upper fork legs.
Turn the screw
back the number of clicks required.
Setting rebound WP
suspension XPLOR
Ø48mm (racing)
Setting rebound
KAYABA (factory)
determine the behavior of the fork
2
located at the lower end
1
clockwise to the stop and go
2
Comfort
Standard
Sport
Comfort
Standard
Sport
.
1
determine the behavior
1
are located at the end
1
clockwise to the stop then go
1
Comfort
Standard
Sport
Comfort
Standard
Sport
18 clicks
15 clicks
12 clicks
20 clicks
12 clicks
8 clicks
18 clicks
15 clicks
12 clicks
18 clicks
12 clicks
10 clicks