Reinstalling The Headlight Housing; Replacing The Headlight Bulb Or The Pilot Lamp - Sherco 250 SE-R Manuel Du Propriétaire

REINSTALLING THE HEADLIGHT HOUSING

3

REPLACING THE HEADLIGHT BULB OR THE PILOT LAMP

1
2
1
3
2
Connect the electrical connector.
Engage the light plate, ensuring that the holes
in the plate are in place
1
Place all of the brake hoses / cables
in the interior of meter upper guide
Attach the rubber fastners.
Check the setting of headlight beam. (
Remove the headlight housing assembly
( p.128)
☛
Remove the protective rubber
Turn the socket a quarter turn counterclockwise
to remove it from the headlight assembly.
Gently press the bulb in while turning it counter-
clockwise and remove it from the socket.
Install a new bulb
2
Headlight bulb S2
Reinstall the socket with the bulb in the headlight
assembly by turning it in a clockwise direction.
Reinstall the protective rubber.
To replace the pilot light
the socket from the reflector
Pilot light W5W
Reinstall the headlight housing assembly
( above)
☛
.
2
.
3
☛
1
.
12V 35/35W S2
simply remove
3
.
2
12V 5W
p.130)
129