Wheels, Tires (Continued); Checking The Tire Pressure - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R

Wheels, tires (continued)

CHECKING THE TIRE PRESSURE

120
1 1 1 1 1 2 2 2 2 2 2 2
Install the rear wheel in the swing arm and install
the axle (grease the axle prior to installation)
Mount the chain.
Install the chain tensioner
but do not tighten.
2
Check the chain tension (
Tighten the nut .
2
Rear Axle nut
Operate the rear brake pedal several times until
the pads touch the disk.
Remove the bike from the stand.
Regularly check the tire pressure with a precision
pressure gauge.
- Remove the valve cap.
- Check air pressure when the tire is cold.
Tire air pressure when used in rough terrain.
Front
Rear
If the pressure does not comply with the above
table :
- Correct the pressure.
- Replace the valve cap.
and install the nut
1
p.114)
☛
M24 100Nm
0,9bar (13 psi)
0,9bar (13 psi)