Electrical System Maintenance; Removing The Battery - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R
Brakes (continued)
2

Electrical system maintenance

REMOVING THE BATTERY

2
126
1
1
3
Install the new pads.
Reinstall the retaining pins
Check the brake fluid level and fill if necessary.
( p.124 and p.126)
☛
CAUTION
Do not use the bike until the brake lever and the pedal
are operational. «Pump» the brake lever / brake pedal
up and down until the brake pads are in contact with
the discs.
Turn off all electric devices and stop the engine.
CAUTION
WAIT AT LEAST 30 SECONDES BIKE TURNED OFF
AND STOPPED SO THAT THE KEYLESS SYSTEM
TURNS OFF.
IF THIS IS NOT DONE THERE IS A SIGNIFICANT
RISK OF DAMAGE TO THE COMPUTER (ECU)
- Remove the seat (
☛
- Remove the air filter (
- The battery is located at the bottom of the filter
housing.
- Remove the two screws
the battery retaining bracket.
- Disconnect the negative cable from the battery
- Disconnect the battery positive cable
- Remove the battery from the top.
and clips
2 1
p.108)
p.108).
☛
that retain
1
.
3
.
2