Chassis Maintenance; Removing The Saddle; Reinstalling Of The Saddle; Removing The Air Filter - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R

Chassis maintenance

REMOVING THE SADDLE

1

REINSTALLING OF THE SADDLE

3
1
2

REMOVING THE AIR FILTER

108
4
1
2
Turn the Dzeus fastner
counterclockwise to release the saddle.
Remove the seat by pulling it towards the back
of the bike.
Install the saddle by sliding it forward, making
sure that the slot
1
the post in the reservoir. The three notches
2
in the saddle must pass through the tabs on the
subframe that are provided for this purpose.
4
Lock the Dzeus fastner by turning it a quarter
turn clockwise.
The air filter is vital for the smooth operation of
your engine. Maintenance is therefore essential.
A dirty air filter reduces the performance of your
bike, increases fuel consumption and, at worst,
impurities can pass into the engine and cause
premature wear.
Remove the seat (
☛
Unscrew the thumb screw
Remove the filter with the plastic carrier
Separate the filter from its plastic holder.
a quarter turn
1
in the seat pan engages
p.108)
.
1
2
.