Wheels, Tires; Removing The Front Wheel; Reinstalling The Front Wheel - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R

Wheels, tires

REMOVING THE FRONT WHEEL

1
3
1
1
118
Place the motorcycle on a suitable stand.
Remove the two screws
2
Loosen the two screws
Pull the axle through the right side.
Remove the wheel from the fork.
Do not operate the front brake lever when the front
wheel is removed.
REINSTALLING THE FRONT
WHEEL
Check that the brake disc is not dirty or
contaminated with oil or grease. If it is, clean
the disc with brake cleaner.
Brake cleaner
Install the spacer
hub.
Install the front wheel in the fork and install
the axle (grease the axle prior to installation).
Tighten the screws
Fork screws
Install and tighten the axle nut
2 Front axle nut
Tighten the screws on the right side of the bike.
Fork screws
Operate the front brake lever several times until
the pads touch the disc.Remove the bike from the
stand and push down on the fork several times.
1
3
ATTENTION
Minerva brake cleaner
on the left side of the wheel
1
.
2
and the nut
2
and degreaser
M8 12Nm
.
3
M20 25Nm
M8 12Nm