Haverland RCB Benjamin Manuel D'installation Et Entretien page 14

Only you can to install the radiator in
ZONE 3.
DO NOT USE THIS HEATER IN THE
IMMEDIATE OF A BATH, A SHOWER
OR A SWIMMING POOL (zone 0, 1 and
zone 2).
1. A suitable location on the wall must be selected. This wall shall be strong and level. Check that there is a mains socket
available nearby.
2. Place the installation template on the wall and mark the locations for the drill holes.
3. Remove the template and drill the required holes in the wall.
4. Install the brackets:
1
4 SCREWS
5. The mains power cable can now be connected to the mains power supply.
3. MAINTAINANCE
- We recommend that all parts of the radiator are kept clean (behind, underneath, upper fins etc.).
- Dust it with a dry and soft cloth when the transmitter is disconnected and is cold.
- Never use disolvents or abrasive products.
- It is convenient to clean the surface of the transmitter at the beginning of the heating season (ALWAYS
BEFORE CONNECTING IT).
Marsan Industrial, S.A. reserves the right to modify without previous warning.
RCB1_2012_MOOR@ESPFRUK2012
14
DANGER
2
PLACE THE
TRANSMITTER
ENGLISH
3
4
3
1
2 SCREWS
1. TO PLACE
2
2. TO LET
3. TO PLACE
SCREW THE
2 SCREWS