Abort Subsystem - Keysight Rp7971A Guide D'utilisation Et De Maintenance

5 SCPI Programming Reference

ABORt Subsystem

Abort commands cancel any active transients and return the trigger system back to the Idle state.
Abort commands are also executed with the *RST command.
ABORt:ACQuire
ABORt:ELOG
ABORt:TRANsient
ABORt:ACQuire - Cancels any triggered measurements. It also resets the WTG-meas and MEAS-active
bits in the Operation Status registers.
ABORt:ELOG - Stops external data logging. It also resets the WTG-meas and MEAS-active bits in the
Operation Status registers.
ABORt:TRAN - Cancels any transients or Arbs. It also resets the WTG-tran and TRAN-active bits in the
Operation Status registers. Note that this command does not turn off continuous triggers if
INITiate:CONTinuous:TRANsient ON has been programmed. In this case, first turn off continuous
triggers before sending the ABORt command.
Parameter
(none)
Aborts the triggered measurement: ABOR:ACQ
188
Typical Return
(none)
Keysight RP7970 & RP7980 Series Operating and Service Guide