WALTHER PILOT PILOT Trend Mode D'emploi page 13

Contents
1 General
2 Safety Instruction
3 Technical Description
4 Connection of Input Lines
5 Operational Handling
6 Adjusting the Spray Pattern
7 Correcting the Spray Pattern
8 Replacement of the Spray Gun Components
9 Cleaning
10 Waste disposal
11 Technical Data
1 General
1.1 Identification of Model Version
Model: Manual Spray Gun PILOT Trend
Type: PILOT Trend-HD Gravity-Feed Cup
PILOT Trend-MD Gravity-Feed Cup
Manufacturer: WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18-30
D-42327 Wuppertal
Telefon: 00 49 202 / 787-0
Telefax: 00 49 202 / 787-217
www.walther-pilot.de • Email: info@walther-pilot.de
V 10 601
V 10 611
1.2 Normal Use
The manual spray guns PILOT Trend-HD and -MD are designed to be used exclu-
sively for sprayable media, such as:
• paints and lacquers
• greases, oils and corrosion preventives
• ceramic glazes
Since the wetted parts aren't made of stainless specialty steel, aggressive materials
shoudn't be sprayed.
If the material you intend to spray is not included in the above list, please contact
WALTHER Spritz- und Lackiersysteme GmbH, Wuppertal, for further information.
Please note that sprayable materials may only be applied to workpieces and /or
similar objects.
The temperature of the spraying material must not exceed 43°C.
The term "normal use" also implies that all safety warnings, operating handling
details, etc., as stated in these operating instructions are carefully read, understood
and duly complied with.
This equipment complies with the explosion protection requirements of Directive
94/9/EC (ATEX 100a) for the explosion group, equipment category and temperature
class indicated on the type plate. When using the equipment, the requirements spe-
cified in these Operating Instructions must be observed at all times.
The technical data indicated on the equipment rating plates and the specifications
in the chapter "Technical Data" must be complied with at all times and must not be
exceeded. An overloading of the equipment must be ruled out.
The equipment may be used in potentially explosive atmospheres only with the aut-
horisation of the relevant supervisory authority.
The relevant supervisory authority or the operator of the equipment are res-
ponsible for determining the explosion hazard (zone classification).
The operator must check and ensure that all technical data and the marking of the
equipment in accordance with ATEX are compliant with the necessary require-
ments.
The operator must provide corresponding safety measures for all applications in
which the breakdown of the equipment might lead to danger to persons.
If any irregularities are observed while the equipment is in operation, the equipment
must be put out of operation immediately and WALTHER PILOT must be consulted.
Grounding / Equipotential Bonding
Measures must be taken to ensure that the spray gun is sufficiently grounded (eart-
hed) by means of a conductive air hose (maximum resistance 10
Ω).
6
2