Yamaha Z250D Manuel D'utilisation page 60

SPEED
TRIP
set
SPEED
TRIP TIME
2-16
YAMAHA
Km/h
knot
mph
km
mile
TIME BATT
mode
000332
Km/h
knot
mph
km
mile
BATT
802032
EMU01275
Clock
This meter shows the current time.
Repeatedly push and release the "mode"
button until the indicator on the face of the
meter points to "TIME." To set the clock, be
sure the meter is in the "TIME" mode. Press
the "set" button; the hour display will begin
blinking. Press the "mode" button until the
desired hour is displayed. Press the "set"
button again, the minute display will begin
blinking. Press the "mode" button until the
desired minute is displayed. Press the "set"
button again to start the clock.
NOTE:
The clock operates on battery power.
Disconnecting the battery will stop the
clock. Reset the clock after connecting the
battery.
EMU01554
Fuel meter
The fuel level is indicated by eight seg-
ments. When all segments are showing, the
fuel tank is full.
cC
The Yamaha fuel tank sensor differs from
conventional sensors. Incorrectly setting
the selector switch on the meter will give
false readings. Consult your Yamaha
dealer on how to correctly set the selec-
tor switch.
NOTE:
The fuel reading can be affected by the
position of the sensor in the fuel tank and
the attitude of the boat in the water.
Operation with bow-up trim or continuous
turning can give false readings.
E