Changing Gear Oil - Yamaha Z250D Manuel D'utilisation

q
4-23
EMU01917

CHANGING GEAR OIL

w
8 Be sure the outboard motor is securely
fastened to the transom or a stable
stand. You could be severely injured if
the outboard motor falls on you.
8 Never get under the lower unit while it
is tilted, even when the tilt support
lever or knob is locked. Severe injury
could occur if the outboard motor
accidentally falls.
w
1) Tilt the outboard motor so that the gear
2) Place a suitable container under the
Z250F
001681
3) Remove the cooling water inlet covers
4) Remove the gear oil drain screw 1.
NOTE:
The gear oil drain screw is magnetic.
w
Remove all metal particles from the screw
before installing it.
q
5) Remove the oil level plug 2 to allow
001392
cC
Inspect the used oil after it has been
drained. If the oil is milky, water is get-
ting into the gear case which can cause
gear damage. Consult a Yamaha dealer
for repair of the lower unit seals.
oil drain screw is at the lowest point
possible.
gear case.
on both sides of the gear case. Be
careful not to lose the bolt and nut.
the oil to drain completely.
E