Adjusting The Cutting Height; Maintenance - Husqvarna AUTOMOWER 405X Manuel D'utilisation

34.4.3 Pair with Automower
Accessories > Automower Connect >
Select the function
Pairing > New pairing . Enter your chosen name of the
product into the app. Automower
connected to your product as long as the mobile device
have contact with the mobile network and the product is
charged and the product is switched on.
34.5 Download firmware over the air
(Firmware over the air FOTA)
The product has a function that automatically downloads
new firmware. When a new firmware is available, a
notification shows in the app where you can select to
install the new firmware. In the factory setting this
function is enabled.

34.6 Adjusting the cutting height

If the grass is long, let the product start mowing at the
MAX cutting height. Once the grass is shorter, you can
gradually lower the cutting height. This can be done
manually or automatic using the TargetHeight function.
TargetHeight lowers the cutting height from MAX to the
specified target height gradually during 10 days.
35.1 Introduction
Speak to an authorized service center for full
maintenance and service of your product.
WARNING:
WARNING:
the ON/OFF button before you turn the
product upside down.
Switch off the product before all work on the
chassis of the product, such as cleaning or
replacing the blades.
WARNING:
the charging station before maintenance, or
cleaning of the charging station or power
supply.
CAUTION:
Push the STOP button and
pull the product out of the charging station
before lifting it. Do not lift the product when it
is parked in the charging station. This can
damage the charging station and/or the
product.

88 - Maintenance

®
Connect
® Connect is always
35 Maintenance
Wear protective gloves.
Switch off the product with
Use the plug to disconnect
CAUTION:
During the first week after a
new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
one step every week until the desired cutting
height has been reached.
34.6.1 To adjust the cutting height
The cutting height can be varied from MIN to MAX in 9
steps.
1. Push the STOP button to stop the product and
open the hatch.
2. Push the MENU button to access the main menu.
3. Move the cursor using the up/down arrow buttons
Cutting height .
to select menu
4. Push OK.
5. Increase/Decrease the cutting height with the
arrow buttons.
35.2 Cleaning
For better operation and longer service life, make sure
to clean the product regularly and replace worn parts.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Clean the product
with a brush or running water from a water hose.
We recommend you to use a special cleaning and
maintenance kit. Speak to your local Husqvarna
representative for more information.
CAUTION:
Do not use a high-pressure
washer to clean the product. Do not use
solvents to clean the product.
35.3 Battery
WARNING:
using a charging station and power supply
which is intended for it. Incorrect use may
result in electric shock, overheating or
leakage of corrosive liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
Only charge the product
1508 - 004 - 22.12.2020