Husqvarna AUTOMOWER 405X Manuel D'utilisation page 80

• A power supply, which is connected to the
charging station and a 100-240V power outlet.
• Loop wire, which is laid around the work area and
around objects and plants that the product must
not run into. The loop wire is used both as
boundary wire and guide wire.
33.3 General preparations
CAUTION:
Holes with water in the lawn
can cause damage to the product.
Note:
Read through the Installation chapter before
beginning the installation. How the installation is done
affects how the product performs. It is therefore
important to plan the installation carefully.
• Make a blueprint of the work area and include all
obstacles. This makes it easier to see the ideal
positions for the charging station, the boundary
wire and the guide wire.
• Make a mark on the blueprint where to put the
charging station, the boundary wire and the guide
wire.
• Make a mark on the blueprint where the guide wire
connects to the boundary wire. Refer to
the guide wire on page 83 .
• Fill in holes in the lawn.
• Cut the grass before you install the product. Make
sure that the grass is maximum 10 cm / 3.9 in.
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.
33.4 Before the installation of the wires
You can select to attach the wires with stakes or bury
them. You can use the 2 procedures for the same work
area.
CAUTION:
If you use a dethatcher in
the work area, bury the boundary wire and
the guide wire to prevent them from
damage.
33.4.1 To examine where to put the
charging station
• Keep a minimum 3 m / 10 ft. of free space in front
of the charging station. Refer to
to put the guide wire on page 81 .
• Keep a minimum of 150 cm / 60 in. of free space to
the right and left of the center of the charging
station.
80 - Installation
•
•
•
max. 5 cm / 2"
max. 5 cm / 2"
•
•
•
To install
33.4.2 To examine where to put the power
supply
To examine where
Put the charging station near a power outlet.
Put the charging station on a level surface.
The baseplate of the charging station must not be
bent.
If the work area has two parts separated with a
steep slope, we recommend to put the charging
station in the lower section.
Put the charging station in an area with protection
from the sun.
If the charging station is installed on an island,
make sure to connect the guide wire to the island.
WARNING:
Do not cut or extend the
low-voltage cable. There is a risk of
electrical shock.
CAUTION:
Make sure that the blades
on the product do not cut the low-voltage
cable.
WARNING:
The power supply cable
and extension cable must be outside the
work area to avoid damage to the cables.
1508 - 004 - 22.12.2020