Installation Of The Product; Installation Tools - Husqvarna AUTOMOWER 405X Manuel D'utilisation

• Make as much free area as possible to the left of
the guide wire when facing the charging station.
• Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
• Do not make sharp bends when you install the
guide wire.
135º
135º
• If the work area has a slope, put the guide wire
diagonally across the slope.

33.5 Installation of the product

33.5.1 Installation tools

• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
33.5.2 To install the charging station
WARNING:
about electrical safety.
WARNING:
used with the power supply unit supplied by
Husqvarna.
WARNING:
supply at a height where there is a risk it can
be put in water. Do not put the power supply
on the ground.
WARNING:
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
WARNING:
Install only to an residual-current device
(RCD) with a tripping current of maximum 30
82 - Installation
90º
Obey national regulations
The product is only to be
Do not put the power
Do not encapsulate the
Risk of Electric Shock.
mA when connecting the power supply to
the wall socket. Applicable to USA/Canada.
If power supply is installed outdoors: Risk of
Electric Shock. Install only to a covered
Class A GFCI receptacle (residual-current
device) that has an enclosure that is
weatherproof with the attachment plug cap
inserted or removed.
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
and the extension cable must be outside the
work area to avoid damage to the cables.
When connecting the power supply, only use a wall
socket that is connected to an residual-current device.
1. Read and understand the instructions about the
charging station. Refer to
the charging station on page 80 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
To install the guide wire on page
installed. Refer to
83 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in.
min 30 cm / 12"
5. Connect the power supply cable to a 100-240V
power outlet.
The power supply cable
To examine where to put
1508 - 004 - 22.12.2020