Lubricating The Bar Tip Sprocket; Adjustment Of The Oil Pump; Cooling System - Husqvarna T435 Mode D'emploi

spark plug should be replaced after about a month in
operation or earlier if necessary.
Note! Always use the recommended spark plug type! Use
of the wrong spark plug can damage the piston/cylinder.
Check that the spark plug is fitted with a suppressor.

Lubricating the bar tip sprocket

Lubricate the bar tip sprocket each time you refuel. Use
the special grease gun and a good quality bearing grease.

Adjustment of the oil pump.

The oil pump is adjustable. Adjustments are made by
turning the screw with a screwdriver. Turning the screw
clockwise will increase the oil flow, turning it anticlockwise
will reduce the oil flow.
The oil tank should become nearly empty by time fuel is
used up. Be sure to refill the oil tank every time when
refueling the saw.
36 – English
MAINTENANCE
!

Cooling system

To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake on the starter.
2 Air guide plate.
3 Fins on the flywheel.
4 Cooling fins on the cylinder.
5 Clutch cover
Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder.
WARNING! The engine must not be
running when making adjustments.