Menu Structure - Husqvarna AUTOMOWER 405X Manuel D'utilisation

the product is not in any specific operating mode,
e.g. if the product has just been switched on. If the
STOP button is pushed the product displays what
it did prior to the stop, e.g.
SEARCHING .
• Date and clock show the current time.
• The satellite symbol is shown when the GPS-
supported navigation is activated. Symbol (A) is
shown when the symbol has made contact with a
sufficient number of GPS satellites. Symbol (B)
shows when the product has not made contact
with a sufficient number of GPS satellites. Symbol
(A) blinks during the first days the product is
working, as it is collecting GPS information about
the installation.
A
• The ECO symbol is displayed if the product is set
ECO mode .
in
• The black clock symbol (A) is shown when the
product is not allowed to mow due to a
setting. If the product is not allowed to mow due to
Weather timer , symbol (B) is shown. If the
Override schedule is chosen,
operation mode
symbol (C) is shown.
A B
• The battery status shows the remaining battery
charge. If the product is loading, a flash is also
shown over the battery symbol (A). If the product is
placed in the charging station without charging, (B)
is shown.
A
• The height adjustment setting is displayed as a
scale/numerical value.
®
• An icon for Bluetooth wireless communication will
appear in the product display when connection
with your mobile device has been established.
®
Refer to Automower Connect on page 87 .
33.12 Keypad
The keypad consists of 6 groups of buttons:
1508 - 004 - 22.12.2020
MOWING or
•
•
•
B
•
•
•
33.13 The indicator lamp
Schedule
The indicator lamp on the ON/OFF button is an
important status indicator:
•
•
C
•
B

33.14 Menu structure

The main menu for the product offers 8 options.
The START button is used to activate the product.
This is normally the last button to be pushed
before closing the hatch.
The BACK and OK buttons are used to navigate in
the menu. The OK button is also used to confirm
settings.
The arrow button are used to navigate in the menu
but also to make selections in certain setting
options.
The MENU button is used to go to the main menu.
The PARK button is used to send the product to
the charging station.
The number buttons are used to enter settings, for
example PIN code, time or exit direction.
The product is active if the indicator lamp lights
continuously.
The product is in power save mode if the indicator
lamp flashes. This means that the operator must
push the ON/OFF button to make the product
active again.
The product is disabled when the indicator lamp is
not lit.
WARNING:
It is only safe to carry out
inspection or maintenance on the product
when the product is disabled. The product is
disabled when the lamp on the ON/OFF
button is not lit.
Installation - 85