Before Use; Precautions For Use - Esoteric K-05Xs Mode D'emploi

Before use

What's in the box
Check to be sure the box includes all the supplied accessories shown
below . Please contact the store where you purchased this unit if
any of these accessories are missing or have been damaged during
transportation .
Power cord × 1
Remote control (RC-1301) × 1
Batteries for remote control (AAA) × 2
Felt pads × 3
Owner's manual (this document) × 1
Warranty card × 1
Maintenance
Use a soft dry cloth to wipe the surface of the unit clean .
For stubborn smudges, use a damp cloth that has been thoroughly
wrung out to remove excess moisture .
o Never spray liquid directly on this unit .
o Do not wipe with chemical cleaning cloths, thinner or other
chemical agents . Doing so could damage the surface .
o Avoid allowing rubber or plastic materials to touch the unit for
long periods of time because they could damage the cabinet .
V
For your safety, disconnect the power cord from
the outlet before cleaning.

Precautions for use

o Do not place anything on top of the unit .
o Do not install this unit in a location that could become hot . This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment . Moreover, do not
place it on top of an amplifier or other equipment that generates
heat . Doing so could cause discoloration or deformation .
o In order to enable good heat dissipation, leave at least 20 cm (8")
between this unit and walls and other equipment when installing
it . If you put it in a rack, take precautions to prevent overheating
by leaving at least 5 cm (2") open above the top of the unit and
at least 10 cm (4") open behind the unit . Failure to provide these
gaps could cause heat to build up inside and result in fire .
o If installing in a rack with a glass door, do not use the remote con-
trol tray OPEN/CLOSE (-) button to open the disc tray when the
door is closed . If the disc tray is forcibly prevented from moving,
damage could result .
o Place the unit in a stable location .
o Do not lift or move the unit during playback because the disc
rotates at high speed . Doing so could damage the disc .
o Always remove any loaded disc before moving this unit or pack-
ing it for installation in a different location, for example . Moving
the unit with a disc inside could cause damage .
o Supply voltage to the unit that matches the voltage indicated on
the rear panel . If you are in any doubt regarding this matter, con-
sult an electrician .
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock . If a foreign object should
get into the unit, contact your dealer .
o When removing the power plug from an outlet, always pull
directly on the plug . Never pull on the cord itself .
Precaution when recording with a connected
device
Some discs include signals to prevent copying . You cannot record the
digital audio signal as is from a disc that has such copy-protection .
(You can record the audio as an analog signal . )
7