Description Of Functions; Technical Data; Charging Time - Parkside Performance Pkhap 20-Li D4 Traduction Des Instructions D'origine

GB MT

Description of functions

The cordless combi hammer is equipped
with an SDS-Plus tool holder, clockwise/
anticlockwise rotation, and an integrated
LED work light.
Please refer to the descriptions below for
information on how the operating ele-
ments work.

Technical data

Cordless Hammer Drill
.............................PKHAP 20-Li D4
Rated voltage U ............................. 20 V ⎓
Weight with battery (Smart PAPS 208)
......................................................... ≈3.7 kg
No-load rotation speed n
–Level 1 .................................. 0-660 min
–Level 2 .................................. 0-950 min
Impact rate
–Level 1 ................................0-3265 min
–Level 2 ................................0-4700 min
Impact energy ................................. 3 Joule
Drill diameter
–wood ............................................. 27 mm
–Concrete/Stone ............................ 24 mm
–metal ..............................................13 mm
Sound pressure level (L
...................................... 93.4 dB; K
Sound power level (L
...................................101.4 dB; K
Vibration Impact drilling
–Main handle(a
h,HD
..........................10.245 m/s²; K=1.5 m/s²
–Auxiliary handle(a
h,HD
..........................13.424 m/s²; K=1.5 m/s²
Vibration Chiselling
–Main handle(a
h,CHeq
..........................11.794 m/s²; K=1.5 m/s²
–Auxiliary handle(a
h,CHeq
..........................17.415 m/s²; K=1.5 m/s²
Battery ................................................. Li-Ion
26
0
)
pA
=3 dB
pA
)
WA
=3 dB
WA
)
)
)
)
Temperature ................................... ≤50 °C
– Charging ................................4 – 40 °C
– Operation ......................... −20 – 50 °C
– Storage .................................. 0 – 45 °C
PARKSIDE Performance Smart battery
Smart PAPS 204 A1/Smart PAPS 208 A1
– frequency band .... 2400–2483.5 MHz
– transmitted power ................... ≤ 20 dBm
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
−1
total vibration value and the stated spe-
−1
cified noise emission value can also be
used for a provisional assessment of the
load.
−1
WARNING! The vibration and noise
−1
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).

Charging time

The device is part of the X 20 V TEAM
series and can be operated with bat-
teries of the X 20 V TEAM series. Bat-
teries of the X 20 V TEAM series may
only be charged using chargers of the
X 20 V TEAM series.
We recommend that you operate
this appliance with the following bat-