Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur page 9

IMPORTANT: Cables should not be slack nor
under tension. Adjust as necessary.
3
OS7030
1. Handlebar Hardware
2. Shift Rod Hardware
3. Shift Rod
4. Speed Selector Lever
Figure 5
Install Discharge Chute and
Discharge Chute Crank
(921013, 022, 023, 031)
(Figures 6 and 7)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing (Figure 6).
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2.
NOTE: Leave discharge chute pedestal loose
to help install the chute crank.
1
2
4
OS7040
4
1. Mounting Holes
2. Discharge Chute
3. Chute Pedestal
4. Discharge Chute Ring
4. Insert the short end of the chute crank
into the hole in the front of the control
panel.
NOTE: Be careful not to damage nylon
bushing when attaching crank to the control
panel.
5. Connect the chute crank to the pinion
gear on chute with hairpin.
GB - 9
1
2
Figure 6
3
1
OS7045