Emission Control System; Safety Rules - Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Keep people away from unit
while operating. Keep children
out of work area and under
watchful care of a responsible
adult.
OL4370
Never direct discharge towards
persons or property that may be
injured or damaged by thrown
objects.
OL0910
Stop engine, remove key, read
manual before making any
repairs or adjustments.
OL4010
Wear appropriate hearing
protection.
OL4690
ONLY use clean-out tool to
clear blockages. NEVER use
your hands.
2. DANGER!
ROTATING PARTS! ONLY use
clean-out tool to clear
blockages. NEVER use your
hands. High speed impeller
rotates below discharge
opening. Wait for all moving
parts to stop before removing
OS6610
clogs or servicing.
3. DANGER!
ROTATING PARTS.
Keep clear of auger while
engine is running.
• Read Operator's Manual.
• Allow operation only by
OS2080
• Stop engine and remove
• Keep all controls, guards
• Never direct discharge

EMISSION CONTROL SYSTEM

This equipment and/or its engine may include
exhaust and evaporative emissions control
system components required to meet U.S.
Environmental Protection Agency (EPA)
and/or California Air Resources Board
(CARB) regulations. Tampering with
emission controls and components by
unauthorized personnel may result in severe
fines or penalties. Emission controls and
components can only be adjusted by an
Ariens Company dealer or an authorized
engine manufacturer's service center.
Contact your Ariens Company Equipment
Retailer concerning emission controls and
component questions.

SAFETY RULES

Read, understand, and follow all safety
practices in Owner/Operator Manual before
beginning assembly or operating. Failure to
follow instructions could result in personal
injury and/or damage to unit.
ALWAYS remove key and/or wire from spark
plug before assembly, maintenance or
service. Unintentional engine start up can
cause death or serious injury.
Complete a walk around inspection of unit
and work area to understand:
• Work area • Your unit • All safety decals
ALWAYS check overhead and side
clearances carefully before operation.
ALWAYS be aware of traffic when operating
along streets or curbs.
Keep children and people away. Keep
children out of work area and under watchful
care of a responsible adult.
NEVER allow children to operate or play on
or near unit. Be alert and shut off unit if
children enter area.
GB - 5
properly trained adult, never
children.
ignition key prior to leaving
the operator's position for
any reason.
and safety devices properly
serviced and functional.
towards persons or property
that may be injured or
damaged by thrown objects.

Publicité

Chapitres

Table des Matières
loading

Table des Matières