Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur page 11

4
1
1. Chute Control Assembly Lever
2. Mounting Bracket
3. Control Assembly Mounting Hole
4. Polyliner Bushing
Figure 9
8. Install rubber grommet removed in
step 4, by stretching rubber grommet
over the top and around chute control
lever.
NOTE: Make sure the groove around the
entire edge of the rubber grommet is properly
seated in the hole in the control panel.
9. Remove the gear cover from the gear
assembly by removing 3/8 inch screw
and lifting up cover (Figure 10).
4
2
3
10. Chute Lock Cable Hook
10. Release the gear assembly teeth by
pushing and on the upper part of the
gear lock. While the gear assembly
teeth are released, rotate the discharge
chute 90° counter-clockwise (Figure 11).
Rotate chute 90° counter clockwise.
Push here to release gear assembly teeth.
IMPORTANT: To ensure the discharge chute
follows its full range of travel, make sure the
control lever is pushed all the way to the left
before installing and pinning the chute rod.
NOTE: Do not remove the small hairpin
installed on the end of the chute rod
(Figure 10).
GB - 11
921017, 018
10
2
5
3
7
1. Chute Rod
2. 3/8 inch Screw
3. Gear Cover
4. Control Assembly
5. Large Hairpin
6. Gear Assembly
7. Chute Lock Cable
8. Alignment Marks
9. Small Hairpin
Figure 10
Figure 11
8
6
9
1
OS7061
OS7271