Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur page 27

REMOTE DEFLECTOR CONTROL
(Figure 28)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control.
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the control panel
(Figure 28).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
1
1. Adjusting Nuts
2. Cable Support Bracket
Figure 28
OS7175
2
GB - 27
QUICK TURN CHUTE CONTROL
(921017, 018)
(Figure 29)
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the gear cover
so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the rear
adjustment nut, and then tightening the
forward adjustment nut against the bracket
until the lock arm engages the gear teeth
(Figure 29).
1. Forward
Adjustment Nut
2. Rearward
Adjustment Nut
Figure 29
If chute does not rotate freely:
Tighten the cable by loosening the forward
adjustment nut, and then tightening the rear
adjustment nut against the bracket until all
cable slack is removed (Figure 29).
OS7181