Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur page 10

.
921013, 022, 023, 031
2
OS7061
1. Chute Crank
2. Control Panel
3. Hairpin
Figure 7
6. Orient the chute and pedestal to its most
vertical position and tighten pedestal
hardware to 15 – 31 lbf-ft (20 – 42 N•m)
(Figure 6).
Install Discharge Chute, Chute
Control, and Chute Rod
(921017, 018)
(Figures 8, 9, 10, 11 and 12)
1. Grease underside of discharge chute
ring (if not already greased) (Figure 6).
2. Remove mounting hardware from auger
housing (Figure 6).
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2
(Figure 6).
NOTE: Leave discharge chute pedestal loose
to help install the chute rod and connect it to
the control assembly.
4. Remove rubber grommet from the
control panel by pinching the long-edged
sides together and pulling upward. Save
rubber grommet (Figure 8).
3
1
1
3
1. Chute Control Assembly Lever
2. Poly Liner Bushing
3. Control Assembly
4. Large Hairpin
5. Rubber Grommet
5. Remove and save the large hairpin from
the control assembly (Figure 8).
6. Route chute control assembly below the
crossbar of the lower handlebar
(Figure 10). Slide the lever of the
assembly through the underside of the
hole in the control panel (Figure 9).
7. Insert the chute control assembly into
the control assembly mounting hole
under the control panel (Figure 9).
NOTE: Be sure the poly liner bushing is
properly seated in the control assembly
mounting hole.
NOTE: Mounted control lever should tip
towards the engine.
GB - 10
2
Figure 8
5
4