Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur page 17

Choke Control Knob
2
1
RUN
CHOKE
OS7275
Throttle
3
The throttle controls the engine speed. To
increase or decrease the engine speed,
adjust to:
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
4. Stop (engine is off)
Electric Starter
The electric starter will start a properly
choked and cranked engine when the starter
button is pushed. Refer to Starting and Shut
Off on page 21.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
Snow Clean-Out Tool
(Figure 17)
WARNING: Hand contact with the
rotating impeller is the most
common cause of injury associated
with snow throwers. Never use your
hand to clean out the discharge
chute.
1.Choke Closed
position: chokes off air
to engine for easier
start.
2.Choke Open
position: allows for
normal operation.
IMPORTANT: Gradual
ly open choke after
engine starts.
1
2
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
Remote Deflector Control
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Place deflector remote in a forward notch to
throw snow lower. Place deflector remote in a
rearward notch to throw snow higher.
Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
Quick Turn Chute Control
(921017, 018)
(Figure 18)
IMPORTANT: If chute does not stay in set
position, adjust as directed in Discharge
Chute on page 28, or repair before operation.
Rotate the Chute with Discharge Chute
Control (Figure 18).
GB - 17
1. Snow
Clean-Out
Tool
Figure 17
1
OS7102