Troubleshooting - La Pavoni PROBAR Mode D'emploi

English
15. TROUBLE SHOOTING
PROBLEMI
The machine does
not work and the
ON light does not
turn on.
no coffee produced
during the coffee
cycle.
coffee produced
too quickly.
coffee is produced
in drips.
coffee leaks
between the coffee
group and the
filter-holder.
Coffee is produced
without froth.
Coffee too cold.
Coffee is too hot
The machine does
not produce steam.
CAUSA
1. No electricity
2. The main cable is not properly plugged in
3. The main cables damaged
1. Coffee too finely ground
2. Too much coffee in the filter
3. Coffee too firmly pressed
4. Shower plate obstructed
1. Coffee too coarsely ground
2. Too little coffee in the filter
3. Coffee not pressed enough
4. Coffee old or unsuitable
1. Coffee too finely ground
2. Too much coffee in the filter
3. Coffee too firmly pressed
1. Filter-holder not properly inserted
2. Too much coffee in the filter
3. Edge of the filter-holder not clean
4. The douche seal is worn or damaged
1. Coffee not suitable for machine
2. Improper grind
3. Too little coffee in filter
1. The machine had not reached the proper
temperature
2. Filter-holder not preheated
3. Cups not preheated
4. Termopid (16) malfunctions.
1. Termopid (16) malfunctions.
1.Pump on steam boiler not functioning
2. Obstructed outlet hole at end of steam
pipe
3. Too little water in tank
SOLUZIONE
1. Restore electrical power
2. Plug the main cable in correctly
3. Contact the nearest service center for a
replacement cable
1. Use a coarser grind
2. Put less coffee in the filter
3. Press the coffee more gently
4. Clean or replace shower plate
1. Use a finer grind
2. Put more coffee in the filter
3. Press coffee more firmly
4. Use different coffee
1. Use a coarser grind
2. Put less coffee in the filter
3. Press the coffee more gently
1. Insert the filter-holder correctly
2. Put less coffee in the filter
3. Clean the edge of the filter-holder
4. Contact the nearest service center
1. Use different coffee
2. Adjust coffee grind
3. Put more coffee in the filter
1. See section 11.1 – 11.3
2. Filter-holder must be heated together with
the water – see section 11.1
3. Properly heat the cups
4. Set the termopid correctly
1. Set the Termopid correctly.
1. Contact the nearest Service center.
2. Clean the outlet hole with a needle
3. See section "Starting the Machine"
30