DeWalt DWE46170 Guide D'utilisation page 8

WARNING: This attachment MUST BE used with a dust extractor
system. ALWAYS wear certified safety face or dust mask.
NOTE: Ensure hose connection is secure.
NOTE: The amount of dust retained by the dust extractor vacuum
is dependent on its filter system. Refer to the dust extractor vacuum
instruction manual for more information.
All D WALT dust collection shrouds are designed to connect and
E
secure easily with the D WALT universal DWV9000 connector. The
E
DWV9000 connector comes pre-installed on some D
extractors. Consult your local dealer for compatible extractors.
CONNECTING THE DWV9000 ONTO THE SHROUD (FIG. 4)
NOTE: If the DWV9000 is not installed on your dust extractor hose
refer to Installing the DWV9000 on a Dust Extraction Hose.
1. With the DWV9000 connector (M) unlocked, slide it onto the
shroud's dust port (F).
2. Lock the DWV9000 connector (M) to secure.
FIG. 4
F
INSTALLING THE DWV9000 ON A DUST EXTRACTION HOSE
(FIG. 5, 6)
The DWV9000 is can be attached to a 1–1/4" or 2–1/2" (31.8 mm or
63.5 mm) dust extraction hose. The DWV9000 can be used with a
2–1/2" (31.8 mm) hose with the use of the DWV9190 adaptor.
For 1–1/4" (31.8 mm) hoses:
WALT dust
E
M
For 2–1/2" (63.5 mm) hoses:
F
6
1. Remove the existing hose connector (L) by twisting clockwise, or
if connector is permanently attached, remove by cutting.
2. Install the universal DWV9000 connector (M) onto the hose by
turning counterclockwise.
FIG. 5
L
1. Use a DWV9190 adaptor (N), and slide it onto the existing hose
connector (L).
2. Install the universal DWV9000 connector (M) onto the adaptor by
turning counterclockwise.
FIG. 6
N
DWV9190
L
M
M