Stadler Form Emma Mode D'emploi page 9

2. Fill the bottle (3) with clean, cold tap water and seal it by putting the lid
(4) on the bottle and turning it as far as it will go.
3. On the housing cover (10), there is a recess in which the bottle (3) is
placed. Place the bottle (3) in this recess with the lid (4) facing down-
wards. Water will now flow into the water tray (11). Important: every time
you take off and put back the bottle (3), some water will run into the tray
(11). If you do this too often, the water tray (11) may overflow and damage
the appliance. We therefore recommend that you only take off the bottle
when it needs to be refilled with water.
4. Switch on the appliance by pressing the On/Off button (12). After it has
been switched on, the LEDs (13) on the left next to the On/Off button (12)
will light up. If not, check to make sure that there is sufficient water in
the tray (11) and that the adapter is connected to the power supply. The
appliance has two humidification output levels which are selected using
the On/Off button (12). Press once for level II/press twice for level I/press
three times to switch off. The number of LEDs (13) indicates which level
you have selected.
5. If you find the LEDs too bright (in a bedroom, for example), you can reduce
the light intensity by pressing the dimmer button (14). There are three
different modes to choose from:
• Normal mode (default mode)
• Dimmed mode (press once)
• Lights-out mode (press twice)
Press the dimmer button (14) again to return to normal mode.
6. Emma is the ideal travel companion and also provides pleasant air humid-
ity in dry hotel rooms. Allow the individual parts of the appliance to dry
completely before placing the housing (5) in the bottle (3) and sealing the
bottle. If you don't have time to do this, simply do it at home or at your
next destination as residual moisture in the sealed bottle can lead to an
unpleasant smell.
7. Allow all the parts of the appliance to dry completely first before you
store Emma. Then open the bottle (3) and store the housing (5) in the bot-
tle. Important: The housing must be placed in the bottle with the mist
outlet at the front (16). Otherwise it will be difficult to remove the housing
from the bottle again (see point B on page 3).
Cleaning
Before maintenance and after every use, switch the device off and pull the
power adapter (8) out of the socket. Before you clean Emma, the power
adapter must be unplugged.
Careful: Never immerse the device in water (danger of short circuit).
• To clean the outside, rub with a damp cloth and then dry thoroughly.
• Cleaning the bottle (3): Clean the bottle once a month using warm water,
a drop of washing-up liquid and a brush or sponge. Then rinse out the bottle
thoroughly. If there are lime deposits in the bottle or on the lid of the bottle
(4), we recommend that you use a household descaling agent or vinegar.
• Cleaning the water tray (11): Clean the water tray once a month. Re-
move the cover (10) from the housing (5). Empty the water tray (11) via the
front of the tray – where the mist outlet (16) is located. This will prevent
water from entering the air outlet opening (15). Now clean the tray using
warm water and the cleaning brush (17) provided. If there are lime deposits
in the water tray, we recommend that you use Stadler Form Cleaner &