To Do A Check Of The Engine Oil Level; Zamenjava Rezil - Husqvarna R 214C Manuel D'utilisation

To remove and install the BioClip plug on the
cutting deck
1. Put the cutting deck in servicing position. Refer to
put the cutting deck in servicing position na strani
115 .
2. Remove the 3 screws that hold the BioClip plug and
remove the plug.
3. Attach 1 M8x15 mm screws in the top screw hole for
the BioClip plug to prevent damage to the threads.
4. Put the cutting deck in the mow position.
5. Install the BioClip plug in the opposite sequence.
Pregledovanje rezil
POZOR:
uravnotežena rezila lahko povzročijo
poškodbe izdelka. Zamenjajte poškodovana
rezila. Za pomoč pri brušenju in
uravnoteženju rezil prosite pooblaščeno
servisno delavnico.
1. Kosišče nastavite v servisni položaj.
2. Oglejte si rezila, da preverite, ali so poškodovana in
ali jih je treba nabrusiti.
3. Vijake rezila zategnite z zateznim momentom 45–50
Nm.

Zamenjava rezil

1. Kosišče prestavite v servisni položaj.
118
Poškodovana ali neustrezno
2. Rezilo blokirajte z leseno klado (A).
C
To
3. Odvijte vijak rezila (B) in ga odstranite skupaj s
podložko (C) in rezilom (D).
4. Novo rezilo z nagnjenimi konci vgradite v smeri
kosišča.
OPOZORILO:
vrste rezila lahko kosišče povzroči izmet
predmetov in povzroči resne poškodbe.
Uporabljajte le rezila, navedena v
Technical data na strani 123 .
5. Namestite rezilo, podložko in vijak. Vijak zategnite z
zateznim momentom 45–50 Nm.

To do a check of the engine oil level

1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
B
D
A
Zaradi neustrezne
1590 - 001 - 11.12.2020