Air Filter; To Replace The Engine Oil - Husqvarna Soff-Cut 150 Manuel D'utilisation

• Examine the concrete surface side. Make sure that
there are no burrs and that the side segments are
not bent.
• Install a new skid plate with each new blade. Do not
use an used skid plate with a new blade.
• Lift the skid plate from the front and from behind to
make sure that the blade moves freely through the
skid plate.
To do a check of the oil level
1. Stop the engine.
2. Put the product on level ground.
3. Remove the oil tank cap with the attached dipstick.
4. Clean the oil from the dipstick.
5. Put the dipstick back in. Do not tighten it.
6. Pull the dipstick out and read the oil level.
7. Examine the oil level on the dipstick.
8. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 28 for correct oil type.
9. Tighten the oil tank cap correctly before you start the
engine.
Note: The engine has an oil alert system that stops the
engine if the oil level is too low. The engine cannot be
started unless the oil level is above the prescribed limit.

To replace the engine oil

Maintenance schedule on page 15 for intervals.
Refer to
WARNING: Engine oil is very hot directly
after the engine stops. Let the engine
become cool before you drain the engine oil.
If you spill engine oil on your skin, clean with
soap and water.
1. Put a container below the drain plug for the engine
oil.
2. Remove the drain plug.
3. Let the oil run out into the container.
4. Attach the drain plug and tighten it.
5. Fill with new oil according to recommendation. Refer
Technical data on page 28 .
to
714 - 004 - 06.07.2021
6. Refer to

Air filter

The air cleaner assembly is a cyclone type, it is on the
engine at the front of the saw. Replace the air cleaner
element, refer to the maintenance schedule. If
necessary, replace more frequently.
For more information, refer to the operator's manual for
the engine.
To do a check of the drive belt
•
Technical data
•
•
•
To replace the guide wheels (Soff-
Cut 150D)
Use the ¼ʺ wide guide wheels when chasing ¼ʺ saw
cuts with the XL6- V25-D blade. Front and rear guide
wheels are included with the saw.
Note: Both front and rear guide wheels must be
replaced; do not mix different width guide wheels.
1. Remove lock nut and slide out the shoulder bolt.
To do a check of the oil level on page 21 for
instructions how to fill oil.
WARNING: Use approved respiratory
protection when you clean or replace the air
filter. Discard used air filters correctly. The
dust in the air filters is dangerous to your
health.
WARNING: Do not clean the air filter with
compressed air. This causes damage to the
air filter and the risk increases that you
breathe the dangerous dust.
CAUTION: Always replace a damaged air
filter, or the dust will go into the engine and
cause engine damage.
Make sure that the drive belt does not have
damages or visual defects.
The belt tensioner controls the belt tension. It is not
necessary to adjust the belt tension.
Make sure that the belt tensioner moves freely up
and down.
Make sure that the belt tensioner bearings move
freely.
21