Husqvarna Soff-Cut 150 Manuel D'utilisation page 16

Maintenance
Do a general inspection.
Examine the oil level.
Clean the product.
Examine the skid plate (Soff-Cut 150).
™
Examine the Lexan cover*.
Examine the blade block guard*.
Examine the cutting blade.
Examine the fuel level.
Clean the spark plug.
Examine the air filter and replace if it is nec-
essary.
Examine the drive belt.
Replace the engine oil .
Lubricate the blade shaft bearings.
Replace the air filter.
Examine and clean the sediment cup.
Examine the spark plug and electrode gap.
To clean the product externally
CAUTION: Always clean the product
immediately after use, before the concrete
becomes dry. Remaining concrete can
cause damage to the product.
1. Remove the blade. Refer to
page 17 .
2. Clean the product with water.
CAUTION: Do not point the water
directly at the engine, especially if you
use a high-pressure washer.
3. Make sure that the handles and levers are clean and
dry before you operate the product.
16
Daily
X
X
X
X
X
X
X
X
To remove the blade on
Weekly, each Monthly, each
40 h
X
X
X
X
4. Clean the blade block and blade from concrete
particles after each use. Use a heavy duty brush and
water. The remaining concrete (A) will dry and set
(B) if you do not remove it.
A B
After the first
20 h, then each
200 h
100 h
X
X
X
X
714 - 004 - 06.07.2021