Product Information; Description Of Device; Lcd Display; Product Specifications - Unitec OBD II Mode D'emploi

20996_Bed.:Layout 1
Operating instructions
GB
DTC -- Diagnostic trouble codes (DTC), that show which area of emission control is not working.
OBD II driving cycle -- a special vehicle operating mode with which a state is to be achieved that is
required to move all readiness monitors relevant to the vehicle to the "Ready" state. A specific driving cycle
must be carried out after the DTCs have been erased from the PCM memory or after the battery has been
disconnected. Going through a complete driving cycle "switches" the readiness monitors "on", so that
future malfunctions can be determined. Driving cycles vary according to vehicle and monitor which must be
reset. You can find vehicle-specific driving cycles in the user handbook of your vehicle.

3. PRODUCT INFORMATION

3.1 Description of device

1. LCD-DISPLAY -- shows the test results.
It is a two-line, back-lit display with
8 characters in each line.
2. OK/ENTER BUTTON -- with this button a selection
(or action) from a menu list is confirmed,
or it takes you back to the main menu.
3. SCROLL BUTTON -- with this button you can
s scroll through the menu items or erase
an operation.
4. OBD II CONNECTOR -- connects the code
scanner to the vehicle's data link connector (DLC).

3.2 Product specifications

1. Display: LCD, 2 lines, 8 characters, back-lit
2. Operating temperature 0 to 50°C
3. Storage temperature: -20 to +70 °C
4. Power supply via removable OBD II heavy-duty cable
5. Dimensions:
Length 126 mm
Width 78 mm
Height 28 mm
6. Weight: 200 g
t
14.04.2010 15:33 Uhr Seite 19
19