Troubleshooting; Specifications; Remote Control Unit (Rc-D40) - Denon DN-D4000 Mode D'emploi

TROUBLESHOOTING

12
Make sure of the followings before you consider as any malfunctions:
1. Are all the connections correct?
2. Are all system components being operated correctly in accordance with the operating instructions?
3. Are the speakers and amplifier/receiver functioning correctly?
If the tape deck still does not function properly, check the symptom against the list below. If the symptom does
not correspond to the check list, please contact your DENON dealer.
Problem
Disc holder does not open/close. • Power operation switch is not
turned on.
When a disc is loaded, "TOC Error" • Disc is not properly loaded.
or "No Disc" is displayed.
When the PLAY/PAUSE ( ) • Disc is dirty or scratched.
13
button is pressed, playback does
not start.
There is no sound, or it is distorted. • Output cord is not properly
connected.
• Amplifier adjustment is
inappropriate.
A specific section of the disc will • Disc is dirty or scratched.
not play.
Programmed playback does not • Programmed playback operation
work. has been performed improperly.
Cause Remedy
• Turn the power operation switch
on.
• Reload the disc.
• Clean the disc.
• Connect the output cord properly.
• Readjust the amplifier.
• Clean the disc.
• Restart programmed playback.

SPECIFICATIONS

13
2 GENERAL
Type: Twin mechanism compact disc player with wired remote control
Disc type: Standard compact discs (12 cm and 8 cm discs)
Dimensions: Player unit:
Remote control unit: 482 (W) x 88 (H) x 62 (D) mm (without feet)
Installation: 19-inch rack mountable
Player unit:
Remote control unit: 2U
Mass: Player unit:
Remote control unit: 1.9 kg
Power supply: U.S.A., Canada and Taiwan R.O.C. models:
European models:
Power consumption: 20 W
Environmental conditions: Operational temperature: 5 to 35°C
Operational humidity:
Storage temperature:
2 AUDIO SECTION
Quantization: 16-bit linear per channel
Sampling frequency: 44.1 kHz at normal pitch
Oversampling rate: 8 times
Frequency response: 20 to 20,000 Hz
Analog output
Output level: 2.0 V
Load impedance: 10 kΩ/kohms or more
Digital output
Signal format: SPDIF
0.5 Vp-p 75 Ω/ohms
Output level:
2 FUNCTIONS
Instant start: Within 30 msec.
Variable pitch: ±4% (0.1% pitch), ±10% (0.1% pitch), ±16% (0.1% pitch)
Pitch bend: Button: ±18%, Jog wheel: +50% to -35%
Search precision: 1/75 sec. (1 subcode frame)
Max. scan speed: Over 20 times normal speed
For improvement purposes, specifications and design are subject to change without notice.
ENGLISH
482 (W) x 88 (H) x 252 (D) mm (without feet)
2U
6.2 kg
120 V AC ±10%, 60 Hz
230 V AC ±10%, 50 Hz
(41 to 95°F)
25 to 85% (no condensation)
–20 to 60°C (4 to 140°F)
15