Troubleshooting; Specifications - Denon DCM-5001 Mode D'emploi

9

TROUBLESHOOTING

If a problem should arise, first check the following.
1. Are all connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
Disconnect the power immediately and contact your store of purchase.
Symptom
LED not lit when power switch
set to on.
Playback does not start in the
stand alone mode.
There is no sound, or it is
distorted.
A specific position of the disc
will not play.
No data is output from the digital
output jack.
CD cannot be played or no sound
is produced when connected in
daisy chain.
10

SPECIFICATIONS

ANALOG
No. of Channels:
Frequency Response:
Wow & Flutter:
Output Level:
Signal-to-noise Ratio:
Harmonic Distortion:
DIGITAL
Output:
DISCS
GENERAL CHARACTERISTICS
Power Supply:
Power Consumption:
Dimensions:
Weight:
HDCD ® and High Definition Compatible Digital ® are registered trademarks of Pacific Microsonics, Inc.
* Design and specifications are subject to change without notice in the course of product improvement.
Cause
• Power cord not plugged in securely.
• There are no discs in the disc rack.
• Is the disc dirty or scratched ?
• The mode switches are not properly set.
• Is the output cord properly connected to the
amplifier ?
• Have the amplifier controls been set correctly ?
• Is the disc dirty or scratched ?
• Is the pin cord properly connected ?
• Is the pin cord (Digital out, in) properly
connected?
• Is the daisy chain control code properly
connected?
• The mode switches are not properly set.
2 Channels
2 ~ 20,000 Hz
Below measurable limit: ( ± 0.001 % W.peak)
2.0 V
100 dB
0.008 % (1 kHz)
75 Ω/ohms)
COAXIAL (0.5 V
P-P
Compact Disc format
AC 120 V, 60 Hz (for North America model)
42 W
434 (W) x 243 (H) x 474.5 (D) mm (17-3/32") x (9-9/16") x (18-43/64")
16.2 kg (35 lbs 11 oz)
Measures
• Check the insertion of the power cord plug.
• Turn the power on with the remote control unit
after turning the POWER switch on.
• Insert a CD.
• Wipe the dirt off the disc or replace the disc.
• Check the mode switch setting.
• Check the connections.
• Adjust the amplifier's controls.
• Wipe the dirt off the disc or replace the disc.
• Check the connections.
• Check the connections.
• Check the mode switch setting.
ENGLISH
Page
9
—
8
14
10
9
–
14
9
12
12, 13
15