Timer-Controlled Playback; Troubleshooting - Denon DCD-1500AE Mode D'emploi

ENGLISH

Timer-controlled playback

Troubleshooting

Check again before assuming the player is malfunctioning
1. Are all the connections correct?
2. Are you following the instructions in the operating instructions?
3. Are the amplifier and speakers operating properly?
If the DCD-1500AE does not seem to be functioning properly, check the table below. If this does not solve the problem, the DCD-
1500AE may be defective. Turn off the power, unplug the power cord from the power outlet, and contact your store of purchase
or nearest DENON sales office.
Symptom
Disc holder does not open or close.
When a disc is loaded, "NO DISC" is displayed.
When a disc is loaded, "00m 00s" is displayed.
When the 1 button is pressed, playback does not
start.
There is no sound or it is distorted.
No data is output from the digital output terminal
(OPTICAL/COAXIAL).
A specific section of the disc will not play.
Programmed playback does not work.
CD-R and CD-RW discs cannot be played.
Incorrect operation when buttons on the remote
control are pressed.
1
Turn on the power of all system components.
2 Set the input selector on the amplifier to
correspond to the inputs the CD player is
connected to.
3
Make sure a disc has been loaded in the disc
holder.
4 Check the time on the timer and then set the
desired turn-on time.
5
Turn the audio timer ON.
Power is turned off automatically in all components
connected to the timer.
6 When the preset turn-on time is reached,
power is turned on in the system components
and CD playback starts from the first track.
• Is the power on?
• Is the disc loaded properly?
• Are you attempting to play a disc other than a CD or Super Audio CD?
• Is the disc dirty or scratched?
• Is the output cord properly connected to the amplifier?
• Have the amplifier controls been set correctly?
• With Super Audio CDs, no digital signals are output.
• Is the PURE DIRECT mode on?
• Is the disc dirty or scratched?
• Has programming been properly done?
• For CD-R/-RW discs, has the disc been finalized?
• Is the remote control unit being operated too far from the CD player?
• Are there obstacles blocking the ray?
• Is the remote control sensor exposed to strong light?
• Are the batteries exhausted?
11
ENGLISH
Check Page
7
2 , 7
2
2
6
–
6
4
2
9
2
3
–
–
–