Inserting The Batteries; Operating Range Of The Remote Control Unit - Denon DCD-1500AE Mode D'emploi

ENGLISH
Getting Started

Inserting the batteries

• The DCD-1500AE can be controlled from a distance using the included remote control unit (RC-1020).
q
Remove the remote control unit's rear cover.
w
Place 2 R03/AAA batteries in the battery compartment in
the direction indicated by the marks.
e
Close the rear cover.

Operating range of the remote control unit

30°
30°
Cautions on Batteries:
• Use R03/AAA batteries in this remote control unit.
• Replace the batteries with new ones approximately once
• If the remote control unit does not operate from close to
• The included batteries are only for verifying operation.
• When inserting the batteries, be careful to do so in the
• To prevent damage or battery fluid leakage:
• Remove the batteries when not planning to use the
• If the batteries should leak, carefully wipe off the fluid
• When operating the remote control unit, point it at the
• The remote control unit can be used from a direct distance
• The remote control unit can be operated at a horizontal angle
NOTE:
• It may be difficult to operate the remote control unit if the
• Do not press the buttons on the main unit and on the
Approx. 8 meters
3
ENGLISH
a year, though this depends on the frequency with which
the remote control unit is used.
the main unit, replace the batteries with new ones, even
if less than a year has passed.
Replace it with a new battery as soon as possible.
proper direction, following the < and > marks in the
remote control unit's battery compartment.
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of
batteries in flames.
remote control unit for a long period of time.
from the inside of the battery compartment, then insert
new batteries.
remote control sensor as shown in the figure.
of approximately 8 meters. This distance will be shorter,
however, if there are obstacles in the way or if the remote
control unit is not pointed directly at the remote control
sensor.
of up to 30° with respect to the remote control sensor.
remote control sensor is exposed to direct sunlight or
strong artificial light.
remote control unit at the same time. Doing so will result
in malfunction.