Remote Control Unit; Inserting Batteries; Using The Remote Control Unit - Denon DCD-SA1 Mode D'emploi

ENGLISH

4 REMOTE CONTROL UNIT

2 The DCD-SA1 can be controlled from a distance using the included remote control unit (RC-997).

(1) Inserting Batteries

q Remove the remote control unit's rear cover.
w Place 2 R03/AAA batteries in the battery compartment in the
direction indicated by the marks.
e Close the rear cover.

(2) Using the Remote Control Unit

30°
30°
• When operating the remote control unit, point it at the remote
• The remote control unit can be used from a direct distance of
• The remote control unit can be operated at a horizontal angle of up
Approx. 8 meters
10
Cautions on Batteries
• Use R03/AAA batteries in this remote control unit.
• Replace the batteries with new ones approximately once a
year, though this depends on the frequency with which the
remote control unit is used.
• If the remote control unit does not operate from close to the
main unit, replace the batteries with new ones, even if less
than a year has passed.
• The included batteries are only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do so in the
proper direction, following the < and > marks in the remote
control unit's battery compartment.
• To prevent damage or battery fluid leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of
batteries in flames.
• Remove the batteries when not planning to use the remote
control unit for a long period of time.
• If the batteries should leak, carefully wipe off the fluid from
the inside of the battery compartment, then insert new
batteries.
control sensor as shown in the figure.
approximately 8 meters. This distance will be shorter, however, if
there are obstacles in the way or if the remote control unit is not
pointed directly at the remote control sensor.
to 30° with respect to the remote control sensor.
NOTES:
• It may be difficult to operate the remote control unit if the
remote control sensor is exposed to direct sunlight or strong
artificial light.
• Do not press the buttons on the main unit and on the remote
control unit at the same time. Doing so will result in
malfunction.