Dimensions And Specifications; Door Alignment - GE 21 Série Manuel D'utilisation Et D'installation

ROLLERS (CONT.)
To adjust the rollers on 21' and 23' models:
Remove the base grille by opening the doors,
removing the screws at each end, and pulling it
straight out.
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
lower it. Use a 3/8"
hex socket or wrench,
or an adjustable
wrench.
These models also have rear adjustable rollers so you
can align the refrigerator with your kitchen cabinets.
Use a long-handled 5/16" socket wrench to turn the
screws for the rear rollers—clockwise to raise the
refrigerator, counterclockwise to lower it.
Replace the base grille.

DOOR ALIGNMENT

After leveling, make sure that doors are even at the top.
To make the doors even, adjust the refrigerator door.
Using a 7/16" socket wrench, turn the door adjusting
screw to the right to raise the door, to the left to lower
it. (A nylon plug, imbedded in the threads of the pin,
prevents the pin from turning unless a wrench is used.)
After one or two turns of the wrench, open and close
the refrigerator door and check the alignment at the
top of the doors.
To remove the base grille,
open the doors, remove
the screw at each end of
the base grille and then
pull the grille straight out.
Installation Instructions
Roller adjusting screws
7/16" Socket Wrench
Raise

DIMENSIONS AND SPECIFICATIONS

(for CustomStyle
70
24" (61 cm)
Cabinet
25
™ models)
" (178.4 cm)
1 ⁄
4
36"
(91.4 cm)
24" (61 cm)
Water Electrical
3/4" (19 mm) Airspace
(1/2" [13 mm] Gap +
1/4" [6 mm] Wall Plates)
25" (63.5 cm)
Countertop