Door Alignment; Dimensions And Specifications - GE Profile CustomStyle 24 Série Manuel D'utilisation

Preparing to install the refrigerator.

Door Alignment

After leveling, make sure that doors are even at the top.
To make the doors even, adjust the fresh food door. Using a 3/16" Allen wrench or a 5/16" socket wrench
(depending on model), turn the door adjusting screw to the right to raise the door, to the left to lower it. (A
nylon plug, imbedded in the threads of the pin, prevents the pin from turning unless a wrench is used.)
After one or two turns of the wrench, open and close the fresh food door and check the alignment at the top
of the doors.

Dimensions and Specifications

20
Remove base grille by opening
the doors and pulling the grille
straight out.
(for CustomStyle models)
"
70 1 /
4
36"
24"
3/16" Allen Wrench
Raise
or
5/16" Socket Wrench
Raise
Water
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24" Cabinet
24" Side Panels
Electrical
25"
Counter Top