Adjusting The Units; Bluetooth Functions - Kettler COACH 2 Instructions De Montage

ADJUstInG tHe UnIts

on the backside of the display, there are two slide switches by means
of which you can adjust your preferred length and energy units. Push
the switch to the right and the display will show you kilometres as length
unit and kilocalories as energy unit. the left switch position will indicate
the energy in kilojoules and the length in miles.

BLUetootH FUnCtIons

You can pair the KettLeR rowing machine with a heart rate monitor device
such as a chest strap which supports Bluetooth® low energy technology.
Additionally, the KettLeR rowing machine can be connected to smart-
phones, tablets and computers as of Bluetooth v4.0, which enables training
with a variety of fitness APPs or computer software.
only one of the two mode can be selected at one time.
1 Use of the APP mode
Before the training, the Bluetooth symbol flashes. If you want to con-
nect your training computer to a smartphone and a corresponding app,
search the rowing machine in the smartphone / tablet before starting
the training. As soon as a connection has been established, the Blue-
tooth symbol and the APP symbol will moreover be permanently lit. Your
training can begin in APP mode.
If you are in APP mode, a Bluetooth heart rate sensor cannot be connect-
ed additionally via the training computer.
tIP: If you do not want to do without your heart rate display, connect
your sensor directly to the smartphone or tablet.
Use of the pulse mode (HR sensor)
If you want to connect a heart frequency sensor to the training comput-
er, start your training as described in the first steps and wait until the
corresponding heart signal becomes visible in the training display. this
process may take several seconds.
ensure that your pulse sensor is active and that you are wearing it on
your body as specified.
the training computer will look for your sensor in the direct vicinity and
will the automatically establish a connection to it. If your signal is lost,
the computer will look for devices and re-establish a connection at an
interval of few minutes.
Repeat this process in the case of a new training session.
TIP: Your heart frequency sensor will only be automatically found and
connected during the training.
ADJUstInG tHe UnIts
| KETTLER
enGLIsH 19
EN