Special Product Features; Mains Connection; Dust Extraction - Metabo Ds W 5175 Notice Originale

must be made of elastic materials, e.g. soft card-
board etc.
Protect sanding discs against shocks, bumps and
grease.
Do not touch the rotating sanding disc!
Only work with the safety cover (1) installed.
Swivel the eye preservers (9) downwards before
sanding.
Use the perimeter of the sanding discs for sanding
- do not use the side of the sanding disc.
Do not reduce the speed of the sanding disc by
pressing on the sides.
The workpiece to be processed must be large
enough, or small enough, to be held safely with
both hands.
High temperatures can result after long-term oper-
ation.
Always wear eye goggles, hearing protection and
protective gloves. Use other available personal
protective equipment, e.g. suitable protective
work clothing. Ensure that sparks produced during
work do not constitute a risk to the user or other
personnel and are not able to ignite inflammable
substances. Endangered areas must be protected
with flame-resistant covers. Make sure that fire-
risk areas are always provided with suitable fire
extinguishers.
Wear a suitable dust protection mask.
The workpiece can become hot during sanding.
5 Overview
See page 3 (please unfold).
1 Safety cover
2 Adjusting nut
3 Clamping flange
4 Sanding disc
5 Back flange
6 Dust extraction connection
7 Safety cover
8 Workpiece support
9 Eye preservers
10 On/off switch with emergency-Stop switch
11 Spark deflector

6 Special Product Features

• Emergency-Stop switch for perfect user safety.
• Robust machines for industrial use.
• Large eye-protection glasses for ideal protec-
tion against flying sparks.
7 Commissioning
7.1

Mains connection

Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match your
power supply.
Ds D 6175, Ds D 9201 (three-phase current
version):
The connector is not included in the scope of
delivery because there are different connector
versions.
Always have the connector connected by
an authorised specialist.
Ensure that the direction of rotation of the
sanding discs is correct.
7.2 Fitting spark deflector and eye preserv-
ers
Install the spark deflector (11) and eye preservers
(9) as show in illustration a, page 3.
7.3 Installing workpiece support
Install workpiece support (8) as shown in illustra-
tion b, page 3.
7.4 Installing machine safely
Place the machine on a stable workbench. Ensure
that the machine is securely seated.
The machine can also be bolted down (screws not
included in the scope of delivery). To do this,
remove the rubber feet and insert the fixing screws
in these holes.
If a stand or wall bracket is used (see Accessories
chapter): bolt down the machine.
7.5

Dust extraction

At the dust extraction connection (6), a dust
extraction unit suitable for double sanding
machines can be connected if required.
Remove the sealing plug beforehand.
ENGLISH
ENG
9