Attaching Or Removing Battery Pack - Panasonic EYFEA1N Instructions D'utilisation

V. ASSEMBLY
Attaching or Removing Bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
1. Attachment
1 While pulling the bit holder
2 Insert the bit
3 Release the bit holder
②
2. Removal
1 While pulling the bit holder
2 Remove the bit
②
9.5 mm (3/8") - 13 mm (33/64") 6.35 mm (1/4")
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
Insert the battery pack firmly into the
main body.
①
①
2. To remove the battery pack:
Push on the button from the side to
release the battery pack.
VI. OPERATION
[Main Body]
Switch Operation
1. The speed increases with the amount
of depression of the trigger. When
beginning work, depress the trigger
slightly to start the rotation slowly.
2. A feedback electronic controller is used
to give a strong torque even in low
speed.
3. The brake operates when the trigger
i s r e l e a s e d a n d t h e m o t o r s t o p s
immediately.
NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
- 8 -
Button