Correct Maintenance (Service Technician); Cleaning Of The Container; Troubleshooting - Bartscher BME91M03 Manuel D'installation, D'utilisation Et D'entretien

ENGLISH
6.2.

Correct maintenance (service technician)

The correct maintenace covers everyday clearing
of all the elements that are in contact with foods.
Careful maintenance
performance, longer life of the appliance and
proper operation of the protective devices.
Never direct the water stream or high pressure jet
towards the appliance.
To clean the stainless steel, do not use iron wool
or iron brush as they may leave iron particles on
the surface that form rust in result of oxidation.
Use the wooden or plastic spatula, or soft
cleaning sponge to remove the dried remains.
GB
6.3.

Cleaning of the container

Follow the guidelines.
Turn off the device and leave to cool down.
Turn on the switch-off to disconnect from the
electrical supply.
Drain water from the tank (see section 5.3).
Clean the tank interior using the cleaning
agent intended for contact with food.
7.

TROUBLESHOOTING

The information below is provided to recognize
and repair any failures that may occur when
operating the appliance.
Problem
No water after opening the
water valve.
The heating coils do not
heat up.
ensures the best
Cause
Incorrect water connection.
The electrical connection is not
correct.
Safety thermostats are on.
Damaged temperature
controller.
In the case of prolonged intervals in the use of the
appliance, apply the vaseline oil onto all the
stainless steel surfaces.
Do not use any clearing agents that
contain substances hazardous or harmful
to health (solvents, petrol. etc.).
At the end of the working day clean:
tank
device.
Regularly instruct the specialist personnel to
perform the following maintenance works:
check the electric installation;
check the safety thermostats.
Rinse with clean water, empty, and dry.
After use wash the equipment parts in suitable
cleaning agent or in the dishwasher.
Some of the failures can be repaired by the user,
others require thorough specialist knowledge.
Such problems may be solved exclusively by the
qualified personnel.
Check water connection.
Contact the service company.
Check the electrical connection.
Reset the device (see special
section).
Replace switch.
Contact the service company.
8
Solution