Installation Of The Appliance In A Line; Check-Up - Bartscher BME91M03 Manuel D'installation, D'utilisation Et D'entretien

B
C
Tighten the cable endings (C).
Replace the terminal strip cover.
8.5.

Installation of the appliance in a line

To fix the appliance in a line (neighbouring) follow
the steps:
1. Dismantle the control panel, and remove the
cast iron frame from the chimney if necessary.
2. Apply the sealing tape (A) onto the joining
sides.
B
8.6.

Check-up

Before starting the appliance the installation
check-up should be run to evaluate the working
conditions of every single
recognize any errors.
The device is equipped with the equipotential
clamp (M).
Respectively to the clamp used a special sticker is
envisaged:
3. Place the appliances next to each other and in
4. Connect the appliances with the joining
It is recommended to run the following check-ups:
component and 1. Check that the energy supply voltage is the
2. Turn on the automatic switch-off to check the
Check that the protection devices work correctly.
11
ENGLISH
M
a horizontal position (by adjusting the feet).
elements.
C
A
same as of the appliance voltage.
electrical connections.
GB
A
C