First Use; Inserting/Replacing The Batteries - Parkside PWT 11 A1 Mode D'emploi

First use

Inserting/replacing the batteries

The appliance is operated with four 1.5 V AA/Mignon/LR6 batteries
(included in delivery).
If necessary, disconnect the appliance from the water connection
♦
and switch it off.
Slide the protective cover q downwards and remove it (see Fig. 1).
♦
Lift the tab and remove the battery compartment cover 0 (see Fig. 2).
♦
Remove the depleted batteries, if necessary.
♦
Insert four 1.5 V AA/Mignon/LR6 batteries into the battery com-
♦
partment. Make sure that the polarity is correct, as indicated in the
battery compartment. The LED of the motion sensor 9 lights up red
briefly. The appliance is now ready for use.
Place the battery compartment cover 0 back on the battery com-
♦
partment. Make sure that the sealing ring is firmly seated (see Fig. 3).
Slide the protective cover q over the battery compartment (see
♦
Fig. 4).
Fig. 1
NOTE
When the batteries are low, the LED of the motion sensor 9 flashes
►
red. The batteries should be changed as soon as possible.
PWT 11 A1
Fig. 2
+
+
−
−
Fig. 3
GB │ IE │ NI
Fig. 4
│
7 ■