Push Stick And Push Block; Applications - Genesis GTS10SB Manuel D'utilisation

1. Turn the ON/OFF switch to the OFF position.
2. Wait about five minutes for the motor to cool down.
3. Push in the reset button (4-FIG 19).
4. Turn the ON/OFF switch to the ON position.
SAWDUST COLLECTION (FIG 20)
This table saw is equipped with a removable sawdust collector
(1). See FIG 20. A dust collection system can be attached to
the dust port (2) to help remove sawdust from the work area.
To remove the sawdust collector, simply loosen two butterfly
nuts (3) and remove the collector from the saw.

PUSH STICK AND PUSH BLOCK

A plastic push stick is supplied for rip cutting widths of 2" to 6"
use auxiliary fence and push block for rip cutting widths
narrower than 2". When ripping, apply the feed force to the
section of the work piece between the saw blade and the rip
fence.

APPLICATIONS

Cutting Tips
1. Make sure the kerf is made on the scrap side of the measuring line.
2. Cut the wood with the finish side up.
3. Always have a proper support for the wood as it comes out of the blade.
4. Make a test cut for important cuts.
5. Always use the correct blade depth setting. The Top of the blade teeth should clear the work piece
by 1/8" (3mm) to ¼" (6 mm).
6. Inspect the work piece for knots or nails before beginning a cut. Remove any loose knots or nails
with a hammer.
7. Always use clean, sharp, properly-set blades, Never make a cut with dull blade.
8. When making a cut, use steady, even pressure, Never force a cut.
9. Do NOT cut wet or warped lumber.
10. Always hold your work piece firmly with both hands or use push stick or push block.
Cross Cutting
warning:
to avoid serious personal injury.
1. Remove the rip fence from the table surface.
2. Position Miter Gauge to 0°.
3. Make sure all loose pieces have been removed from the table surface and work piece is not in
contact with blade.
4. Turn ON/OFF switch to the ON position.
5. Position the work piece flat on the table with edge flush against miter gauge fence. Wait until
blade reaches full speed before feeding the work piece into the blade.
6. use two hands to slowly feed the work piece and miter gauge toward the blade. use the hand
furthest from the blade to keep the work piece flush against miter gauge fence and use your other
hand to push the miter gauge and work piece toward the blade. Stand slightly to the side of the
blade to reduce the risk of injury should kickback occur.
7. Continue feeding the work piece into the blade until the cut has been completed.
8. Once the cut has been completed, pull the work piece back toward you.
18
Make sure the blade guard assembly is properly installed
10" Table Saw
Operator's Manual
1
2
1
GTS10SB
3
FIG 20