Unpacking And Contents; Assembly And Adjustments; Blade Installation - Genesis GRS750 Manuel D'utilisation

KNOWING YOUR RECIPROCATING SAW
1. Trigger Switch
2. Lock-On Button
3. Rear Handle
4. Quick-Release Blade Clamp
5. Pivoting Shoe
6. Blade
7. Rubber Boot
4
6
5

UNPACKING AND CONTENTS

IMPORTANT:
Due to modern mass production techniques, it is unlikely the tool is
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Reciprocating Saw
Wood-Cutting Blade
Metal-Cutting Blade

ASSEMBLY AND ADJUSTMENTS

WARNING:
adjusting, adding accessories, or checking a function on the tool.

BLADE INSTALLATION

Check that the blade you are inserting matches the material you are cutting. Start with a sharp blade. Twist the
Quick-Release Blade Clamp (4) as far as it will go in the direction of the engraved arrow (counterclockwise if facing
the saw). Slip the new blade into blade clamp as far as it will go. Release the blade clamp. The new blade should
now be securely fastened.
CAUTION:
Make sure the blade is securely fastened each time before using the saw.
ADJUSTING THE DEPTH OF CUT
The front Pivoting Shoe (5) can be adjusted to change the depth of cut of your reciprocating saw. To adjust the
depth of cut, loosen the two front Shoe Locking Screws (located on the bottom of the Saw Boot) by inserting the
provided Allen wrench and rotating counter-clockwise. Set your depth of cut (Note: ideal depth of cut is 1" deeper
than material to be cut), then tighten the front Shoe Locking Screws securely.
7
Q'ty Description
1 Allen Wrench
1 Operartor's Manual
1
Always be sure that the tool is switched off and unplugged before
1
FIG 1
Q'ty
1
1
2
3
7