Assembly And Adjustment - Genesis GTS10SB Manuel D'utilisation

aSSeMblY anD aDJUSTMenT

warning:
complete. Failure to comply could result in accidental starting and serious
personal injury.
warning:
assembly the table saw, plug in the power source, or turn the switch on until the
missing or damaged part is obtained and it installed properly.
WORK STAND ASSEMBLY
Part Needed
9. Short Top Brackets (A)
10. Long Top Brackets (B)
11. Short Support Bracket (C)
12. Long Support Bracket (D)
13. Stand Legs
14. Rubber Feet
15. Screws, Washers & Nuts
use Screws, Washers and Nuts (15) to attach the stand
pieces. Do not tighten the screws completely until leg
stand is completely assembly. (See FIG. 3)
1. A ttach the short top brackets 9 (A) to the stand legs 13.
2. A ttach the long top brackets 10 (B) to the stand legs 13
3. A ttach the short support brackets 11 (C) to the stand legs 13
4. A ttach the long support brackets 12 (D) to the stand legs 13
5. T ap the four rubber feet 14 onto the bottom of the stand legs 13
6. T ighten all fasteners.
warning:
an unstable stand may shift in use and cause serious personal injury.
MOUNTING THE TABLE SAW ON STAND
1. Place the table saw on to the assembled stand so that the
four mounting holes in the base of the saw are over the
four mounting slots on the stand.
2. Secure the table saw to the stand by using the four bolts,
washers and nuts provided. (See FIG.4)
MOUNTING THE TABLE WITHOUT STAND
When mounting table saw to a work bench or plywood,
holes should be drilled through the supporting surface to the
work bench or plywood and an opening must be made the
same size as the opening in the bottom of the saw using the
dimensions illustrated so the saw dust can drop through.
1. Place the saw on the mounting surface, and mark the
location of the four 3/8" mounting holes.
2. Remove the saw. Drill 3/8" holes in the mounting surface
3. Mark an 11" x11" square centered between four mounting
holes.
12
DO nOT connect to power source until assembly is
if any part is missing or damaged, do not attempt to
2
2
2
2
4
4
32 sets
after completing adjustments, securely tighten all fasteners.
10" Table Saw
Operator's Manual
9
15
13
10
12
FIG 3
GTS10SB
10
12
13
9
11
14
FIG 4
FIG 5