Honda UMR435T Manuel De L'utilisateur page 52

3. Cutting attachment replacement
Nylon-line cutting head:
• To avoid severe personal injury, make sure that the engine switch is in the
OFF position to prevent accidental starting.
• Use a genuine Honda replacement cutting head or its equivalent.
CAUTION:
Wear heavy gloves to protect your hands when replacing the cutting head.
1. Stop the engine and remove the spark plug cap.
2. Insert a 4 mm hexagon wrench into the locking tool hole to keep the drive shaft
from turning.
3. Turn the cutting head assembly clockwise to remove it from the gear case.
Replace it with new one.
The line feeding action of the semi-automatic line feed type cutting head (see
page 30).
4 HEXAGON WRENCH
CUTTING HEAD
ASSEMBLY
LOCKING TOOL HOLE
GEAR CASE
49