Switching On - ETNA VWV549WIT Mode D'emploi

OPERATION

Switching on

1. Open the door.
2. Add detergent and rinse agent (consult 'Dishwasher detergents' and 'Rinse aid'). Check the
amount of salt in the salt reservoir (consult 'Adding Salt').
3. Press the "on/off" button to switch on the appliance.
The power indicator will light up when the appliance is switched on.
4. Select the desired cycle by pressing the program button (see cycle selection table").
The cycle indicator corresponding to the selected cycle will light up.
5. Close the door.
The dishwasher will automatically start running the selected cycle.
Stopping or changing a wash cycle
• Open the door.
• Press and hold the program button for more than 3 seconds. You can now re-select the
desired cycle (see "cycle selection table").
• Close the door.
Note! A cycle that has already begun can only be changed in the start-up phase. After
this, the detergent will be sprayed all over the dishes or the machine may have already
pumped out the water. In that instance, you must refill the detergent compartment (see
section on Detergent compartment).
Following the end of the wash cycle
Once the wash cycle has completed, an audible signal will sound for eight seconds.
• Open the door.
• Switch the appliance off using the on/off button. Wait a few minutes before unloading the
dishwasher. The dishes and cutlery will still be very hot immediately following the end of the
cycle. There is a chance that dishes may break as a result of the heat. Moreover, the dishes
dry better when allowed to stand for a few minutes.
EN 8